I realize that reducing the diameter of the cylinder would also require
increasing the length of the stroke. I did not feel that it was necessary to
explain this to a technical audience.
--
Max Heim
'66 MGB GHN3L76149
If you're near Menlo Park, CA,
it's the primer red one with chrome wires
on 3/21/13 1:42 AM, PaulHunt73 at paulhunt73@virginmedia.com wrote:
> Certainly you can, and reduce the travel of the release bearing at the same
> time. But you would have to ensure that the travel was still enough to
> fully release the friction plate or you would have difficulty selecting
> gears, and it would put the biting point closer to the floor. The ratio of
> master diameter to slave diameter is what it is for a reason.
>
> PaulH
>
>
> ----- Original Message -----
>> Hmm, I wonder... Since it's a simple hydraulic system, it should be
>> possible
>> to alter the amount of effort needed to depress the clutch pedal.
_______________________________________________
Mgs@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/mgs/mharc@autox.team.net
|