[Top] [All Lists]

Re: Pouring a garage floor

Subject: Re: Pouring a garage floor
Date: Fri, 8 Nov 2002 13:35:03 EST
In a message dated 11/8/02 9:56:48 AM Pacific Standard Time, writes:

> You will get floor cracks if you don't reinforce, so you'll want something 
> in the concrete. But you can just get the 6" square reinforcing mesh if you 
> don't intend to drive on it. 

- - - - - - - - - - - - -

This is just in the attached shop area, not the garage where the cars are.  I 
will probably be able to bring in a long-term project car at some time in the 
future, but it would be limited in size to say an MG Midget, and it would 
probably not be whole, because it would be a project!  

Do you think a grid of re-bar is a better way to go?  What spacing?  I really 
don't want to go to the expense of more than 4" of concrete.

Allen Hefner
Phila. Region SCCA Rally Steward
'77 MG Midget
'75 MG Midget (The Project)
'92 Mitsubishi Expo LRV Sport

///  unsubscribe/change address requests to  or try
///  Archives at

<Prev in Thread] Current Thread [Next in Thread>