shop-talk
[Top] [All Lists]

Re: What kind of screw is this?

To: "Kai M. Radicke" <kai@radiohead.net>
Subject: Re: What kind of screw is this?
From: Dave & Marlene <rusd@velocitus.net>
Date: Wed, 05 Mar 2003 23:11:43 -0700
Kai,

Have you tried a Torx bit to see if it will fit? Another very good 
possibility is to grind the tip of a flat blade screwdriver to fit 
inside of two opposing slots.

Dave Russell

Kai M. Radicke wrote:

> 
> Well, I guess I should have clarified that, two of the screws on the dashpot
> are not removable using my snap ring pliers because they are located too
> closely to obstructions on the carb body.
> 
> If I can find a pair of snap ring tips that are bent at 90 degrees tomorrow
> at Lowes, that might do it, but I'm not optimistic about that working.
> 
> Kai

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/shop-talk


<Prev in Thread] Current Thread [Next in Thread>