No (I think), what I'm looking for is to cut off an outside
point from each 90 degree corner. The radius will be
less than 3/8" and it must look perfect. I believe what
you're referring to is a hand nibbler more suitable for
large radius work. Maybe I'm looking for a notcher
capable of radiusing small corners? Any possible source?
Thanks.
Steve Hammatt
Mount Vernon WA USA
----- Original Message -----
From: "Mark" <mark@nashvilletn.org>
To: "Steve Hammatt Mount Vernon WA USA" <gsteve@hammatt.com>
Sent: Tuesday, March 24, 2009 5:29 PM
Subject: Re: [Shop-talk] making radiused corners on sheet metal
> Nibbler, you were close. There are electric, air and manual
> versions.
>
> Mark
> Nashville
> http://www.arrestmered.com
> 58 "Bugeye"
> 66 TR4A
>
>
> ----- Original Message -----
> From: "Steve Hammatt Mount Vernon WA USA" <gsteve@hammatt.com>
> To: "Shop Talk" <shop-talk@autox.team.net>
> Sent: Tuesday, March 24, 2009 7:23 PM
> Subject: [Shop-talk] making radiused corners on sheet metal
>
>
> I'm soon going to be making some rectangular
> pieces of .040 aluminum sheet and I'll need to
> radius the corners. I'm at a loss for what to call
> the tool that can nip-off the corners. Can anyone
> give me a hint on the name or possible source for
> the tool?
> Thanks
>
> Steve Hammatt
> Mount Vernon WA USA
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> You are subscribed as mark@nashvilletn.org
>
> Shop-talk mailing list
>
> http://autox.team.net/mailman/listinfo/shop-talk
>
> http://www.team.net/archive
--------------------------------------------------------------------------------
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.0.238 / Virus Database: 270.11.26/2020 - Release Date:
03/24/09 09:19:00
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Shop-talk mailing list
http://autox.team.net/mailman/listinfo/shop-talk
http://www.team.net/archive
|