Mark,
The anode, only a few models, is integral to the hot water nipple.
Typically, it's a hex head.
Once the pipe is removed from the nipple, the nipple unscrews just like any
other nipple, but it has a 3+ foot anode attached.
Sound bad, but it's simple.
Jack
-----Original Message-----
From: shop-talk-bounces@autox.team.net
[mailto:shop-talk-bounces@autox.team.net] On Behalf Of Mark Andy
Sent: Tuesday, January 26, 2010 7:54 AM
To: Shop Talk List
Subject: Re: [Shop-talk] Water heater problem
Howdy,
On Tue, 26 Jan 2010, Wayne wrote:
>> There certainly was one on my last gas water heater, but I don't see
where
>> it is on the Bradford White I have now.
>
> On some of them it's integrated into the cold water inlet tube. See the
web
> site at the top. It has brand specific info.
I'll check the site as well, but if the anode is integrated into the water
inlet, does that mean you really want threaded / flexible connections to
the cold water supply to facilitate changing it?
Mark
Suggested annual donation $12.96
You are subscribed as jibjib@att.net
Shop-talk mailing list
http://autox.team.net/mailman/listinfo/shop-talk
http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation $12.96
Shop-talk mailing list
http://autox.team.net/mailman/listinfo/shop-talk
http://www.team.net/archive
|