shop-talk
[Top] [All Lists]

Re: [Shop-talk] torque wrench calilbration

To: David Scheidt <dmscheidt@gmail.com>
Subject: Re: [Shop-talk] torque wrench calilbration
From: Bob Spidell <bspidell@comcast.net>
Date: Sat, 5 Mar 2011 17:32:47 +0000 (UTC)
You speak with a great deal of certainly, so I won't dispute that, but the 
calibration techniques I'm familiar with measure the wrench's indicated torque 
against a calibrated strain gauge (which itself must be calibrated, etc.). I 
don't see why you couldn't at least get a calibration card for a beam-style 
wrench; e.g. the wrench indicates 50lb-ft, and the strain gauge measures 52, so 
you know your wrench reads a bit low in the 50lb-ft range. 

To me, 'calibration' means comparing to a known quantity. Adjustment means 
bring them into agreement. 


Bob 

-------------------------------- 
Bob Spidell - San Jose, CA 


On Sat, Mar 5, 2011 at 10:13 AM, Bob Spidell <bspidell@comcast.net> wrote: 
> Check your local yellow pages under 'scientific,' 'laboratories,' 
> 'calibration,' etc. 
> 
> Also, if you have a general aviation airport nearby call the Fixed Base 
> Operator ('FBO') or flight school. Torque wrenches used on aircraft have to 
> be calibrated regularly--once a year, I think--and an Airframe & Powerplant 
> ('A&P') mechanic would know where to get it done. 
> 
> Last I checked it cost about $25. 
> 

You can't calibrate, nor even certify accuracy of, a beam style torque wrench. 



-- 
David Scheidt 
dmscheidt@gmail.com 
_______________________________________________

Shop-talk@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation  $12.96
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

<Prev in Thread] Current Thread [Next in Thread>