afaik, simple flat tops should do it. the combustion chamber size is
uniform for all the heads.
mike
-----Original Message-----
From: Ken C [mailto:sdspitfire@worldnet.att.net]
Sent: Tuesday, October 24, 2000 6:33 PM
To: Spit Elist
Subject: 1500 Cylinder head
Spitlisters,
I have read or heard that the USA 1500cc cylinder head is 'deeper', and,
along with dished pistons, typically yields 7.5 to 1 compression. If flat
top pistons were used, any idea how much the head have to be milled in order
to bring everything up to 9.0 to 1 ? Would shorter push rods be needed ?
Ken C
'72 Spit
This message is for the named person's use only. It may contain
confidential, proprietary or legally privileged information. No
confidentiality or privilege is waived or lost by any mistransmission.
If you receive this message in error, please immediately delete it and all
copies of it from your system, destroy any hard copies of it and notify the
sender. You must not, directly or indirectly, use, disclose, distribute,
print, or copy any part of this message if you are not the intended
recipient. CREDIT SUISSE GROUP and each of its subsidiaries each reserve
the right to monitor all e-mail communications through its networks. Any
views expressed in this message are those of the individual sender, except
where the message states otherwise and the sender is authorised to state
them to be the views of any such entity.
Unless otherwise stated, any pricing information given in this message is
indicative only, is subject to change and does not constitute an offer to
deal at any price quoted.
Any reference to the terms of executed transactions should be treated as
preliminary only and subject to our formal written confirmation.
|