A typical hardware store doesn't carry the thread pitch necessary. Don't
remember the designation, but it's not the hardware fine/coarse. I've had no
problem buying boxes of the proper nuts and bolts from automotive parts stores.
They carry these little boxes of nuts bolts and washers. My must commonly
used fasteners are of the 1/4" size. 3/4" and 1" long. Seems like most of the
car was built using these.
If you're going for proper restoration, do be aware that the nuts and bolts you
buy this way will not carry the oem correct markings on the heads, and will
have an incorrect surface finish.
-----------------------------------------------------
The information contained in this communication may be confidential, is
intended only for the use of the recipient named above, and may be legally
privileged.
If the reader of this message is not the intended recipient, you are hereby
notified that any dissemination, distribution, or copying of this
communication, or any of its contents, is strictly prohibited.
If you have received this communication in error, please re-send this
communication to the sender and delete the original message and any copy of it
from your computer system. Thank you.
-----------------------------------------------------
<<<<GWIASIG 0.07>>>>
|