Mark,
I use a cheap 1/2" extension that I ground a taper on with the bench
grinder. Just keep grinding an trying until it fits.
Regards,
Peter S.
>Date: Sun, 07 Feb 1999 18:51:02 -0800
>From: Mark Snowdon <racer45@bellsouth.net>
>Reply-To: racer45@bellsouth.net
>To: mrbugeye@hotmail.com
>CC: spridgets@autox.team.net
>Subject: Rear end drain plug tool
>
>Did anyone ever come up with what size bit(socket with stub) was needed
>to pull the rear end fill plug? I remember a few people who had ground
>down a larger allen key or similar tool to fit the hole in the plug,
but
>what is the size that I can tell the Mac Tool guy next time I see him.
>
>Mark Snowdon
>with a Sprite raring for the road......
|