"Noel, William M" wrote:
> Two question for a '72 Midget:
> Does the capillary tube for the temperature gauge have a bracket or stay of
> some kind between the firewall and the engine? If so describe what the
> bracket is and where it attaches.
Yes, 2 or 3 small clips which screw to the body (10/32 screws)
2 are on the inner fender well under where the heater duct goes, 1 is
near the brake blanking plate.
> The oil pressure line within the engine compartment where it emerges from
> the firewall has a metal clip which attached to the line. This is the metal
> part of the line which only extends about 6" to 8" inside the fire wall.
> What is this clip anchored/screwed to?
Same type set up, a 10/32 screw near the brake blanking plate kind of
behind the solenoid on the side of the heater, there should be a
threaded hole for it.
Toms River, NJ