spridgets
[Top] [All Lists]

Re: Ring gear

To: <spridgets@autox.team.net>
Subject: Re: Ring gear
From: "Steve Byers" <byers@cconnect.net>
Date: Sun, 28 Mar 1999 12:09:05 -0500
Reply-to: "Steve Byers" <byers@cconnect.net>
Sender: owner-spridgets@autox.team.net
Hi, Frank!
Yup, the BMC manual says to heat the ring to 350 deg. C  (about 660 deg.
F).  It also says it might just be possible to fit the ring at a
temperature of 250 deg. C (about 480 deg. F), which it points out is the
max temperature of most home ovens, but that it is unlikely and undue force
should not be used.
I thought about doing it at home, too, but was afraid I'd get the ring
partially on and it would seize, and I'd then be up a creek.
If you're gonna do it, I'd set the oven as high as it goes and bake the
ring for at least an hour.  You want to make sure the ring is stabilized at
the highest temperatures it's going to get before trying to install it.
Good luck!

Steve Byers
Havelock, NC USA
'73 Midget GAN5UD126009G  "OO NINE"
"It is better to remain silent, and be thought a fool
than to speak, and remove all doubt"  -- Mark Twain


----------
> From: Frank Clarici <spritenut@Exit109.com>
> To: spridgets@autox.team.net
> Subject: Ring gear
> Date: Sunday, March 28, 1999 9:55 AM
> 
> This will be my first attempt at replacing a ring gear on the flywheel.
> As I type the flywheel is in the freezer.
> My question is, what temperature do I set the oven at? And how long do I
> "bake" the ring gear?
> I seem to recall 600 degrees but the wife's oven only goes up to "broil"
> which is about 500.
> Thanks in advance.
> Suzy homemaker I am not!
> -- 
> Frank Clarici
> Toms River, NJ
> Bugeye Sprite
> 67 Sprite
> 59 A40
> http://www.exit109.com/~spritenut/

<Prev in Thread] Current Thread [Next in Thread>