spridgets
[Top] [All Lists]

Re: LBC problems

To: spridgets@autox.team.net
Subject: Re: LBC problems
Date: Wed, 19 Jan 2000 09:10:19 -0500
References: <38853A3B.56FFFA2D@exit109.com> <3885AB81.E3F2081B@htcomp.net>
Frank,

You may have hit the nail on the head with you concern about the 
1.75" SU. Possibly one way of fooling it into thinking it's working 
is to center a ceramic cube heater under the front bumper and point 
it back towards the engine compartment. This not only warms the oil 
and block, but also the carb and float bowls, allowing the inadequate 
choke to become adequate.  The other suggestions about going to an 
electronic ignition and more powerful coil may also work, because as 
you know, the spark plug gap can be opened quite a bit and thus 
hopefully be able to burn the lees-than-perfect mixture. Maybe. I 
recall that you had a failure with a Pertronix Ignitor. This may have 
been due to turning the engine over, like during a tune-up, with some 
or all of the wires to the the coil and distributor still connected. 
In one of their troublshooting lists, Pertronix basically says 'don't 
do this'. Not prominently displayed.

Gotta go!

Jeff
Jeff Boatright    __o_\__           '65 Austin-Healey Sprite
http://userwww.service.emory.edu/~jboatri/sprite/sprite.html

<Prev in Thread] Current Thread [Next in Thread>