Drew, I don't think I was on your back about the spacers. Yes I don't
believe you need them with the tapered bearings and don't run them on my
car, but your right it is your car and you can do what you want.
When we went through this I asked for the reasons why the spacer
would strengthen the axle. The answers I got were because "so and so said
so". The only person that tried to explain it using sound engineering
theory had his mechanics of materials wrong. If anybody can or wants to
prove that the use of a spacer between the bearings adds strength to the
axle, they have chosen not to so far.
You are right in thinking that if you are going to use the spacer it
must not affect the pre-load of the tappered bearing. I still believe the
only use for the spacer and shims is to provide the proper pre-load on the
ball bearings and that this placing the axle in a constant state of tension
in fact makes it weaker.
MiniMania sells the tappered cone bearings and Don recomends using
the spacers, but do they sell shims? Good luck in you quest.
Crash
>And regarding my question about "Where to find" these wheel bearing spacer
>shims (Chris, Daniel, Paul, Dave, David and Crash)... Have a little
patience
>and Get off my back!
>I know how to use the archive listings and I already made my decision on
>what to do, I was merely looking for a source of the parts which I didn't
>find in the archives. Just because you're setting your cars up a different
>way doesn't mean it's the only way. I know that I don't have to use the
>bearing spacer with the tapered roller bearing, but I was advised to by 3
or
>4 H & F production racers and Mini Mania (not that I think they are always
>correct either) because I need the extra support because I'm running a 7"
>wheel w/ a 50 series tire.
>Taking every advantage to keep my stub axels from breaking,
>-Drew
|