spridgets
[Top] [All Lists]

Re: Rough running Midget

To: Bill Gilroy <w.gilroy@verizon.net>
Subject: Re: Rough running Midget
Date: Fri, 07 Sep 2001 23:09:50 -0700
Cc: spridgets@autox.team.net
References: <058988711.20010907234934@verizon.net>
Bill,
     Did you replace the condensor?  The condensor's job is to keep the points
from pitting.
Mike MacLean Supercharged 60 Sprite

Bill Gilroy wrote:

> Earlier this week I posted about my rough running 77 Midget.  The
> consensus seemed to be start with the electrical system.  This is what I
> found.
>
> 1.  The plugs were fine.
> 2.  The gap on the points was < .015 and they seemed pitted.  At least
> they were not shinny and new.  I replace and re-gapped the points.
> 3.  The dizzy cap was shot.  The carbon post on a spring that goes to
> the center of the rotor was completely burnt away.  The rotor also had
> a big burn on the center where the post used to connect.  I replace
> both the cap and rotor.
> 4.  I could not find any carbon traces anywhere until I started to
> remove the spark plug wires.  The number 1 wire had carbon traces only
> were the wire went into the cap.  I am using an older cap with the
> post that screw into the wires.  Since the wires were a bit long I
> trimmed them all back and reused them.  The number 1 wire I replace.
>
> All of these parts were replace about 1K  ago.  It seemed a bit
> fast to pit the points.  The wire I am not sure why I had carbon
> traces.  The real question is why did the center post in the dizzy
> just get burnt away in such a short period of time?  Any ideas.
>
> Anyway when I got done the car ran fine so I have fix my problems for
> until the next 1K miles.
>
> --
> Later,
>  Bill                         mailto:w.gilroy@verizon.net
>
> "Facts are the enemy of truth"
> 77 Midget
> 90 Shar-Pei



<Prev in Thread] Current Thread [Next in Thread>