Hi again,
Need to know how the cover goes on the door pockets. The PO to the PO
took them off and stripped them years ago, so there's no tell tale
indications. First I POR15 the brackets and rivet them on, apply the
foam pad to the face, apply the vinyl to that, right? Then, I wrap the
vinyl around the bottom and ends, trimming it to fit under the brackets
about 1/2 to 3/4 inch and glue it down. Next, slip on the top edge metal
curve thingy. FOld over the the top of the vinyl, miter folding the ends
and glue about 2 inches worth down from the top before trimming. That's
what it looks like I should do, all based on a 1/2 x 1/2 scrap that was
stuck under the top metal edge at the one corner.
Seats came out good, generator back to the shop with the regulator (not
charging), cleaning windscreen frame and glass, bonnet should go on
tomorrow or Sunday.
Thanks in advance
Dave
60 3000 "Helaey Bits" (in more pieces than they built it from)
60 Bugeye "Little Bits" click the link below for pictures
http://members.bellatlantic.net/~vze2z49v/bugeye.htm
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|