[Top] [All Lists]


To: <spridgets@autox.team.net>
Subject: Radiator
Date: Thu, 20 Jun 2002 07:58:28 -0700
Concerning the quick remove mod, I've only done it to cross-flow radiators
on my 1275s.
What you do is drill out the spot welds that hold the top piece on the
shroud and replace with screws. The bottom bolts that hold the radiator to
the shroud are replaced with studs and no nuts. Then when pulling the
radiator just take the screws out of the top and pull the whole thing up and
out leaving the other 3 sides of the shroud in place.
Make sense?

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/spridgets

<Prev in Thread] Current Thread [Next in Thread>