[Top] [All Lists]

Re: Attaching 1500 engine to stand

To: <spridgets@autox.team.net>
Subject: Re: Attaching 1500 engine to stand
Date: Sun, 30 Jun 2002 18:03:25 -0400
It looks like I can remove the rear bearing cap with the backplate in place; 
it's in plain sight. The front one looks like it's under some sort of cross 
plate. I'll have to double check my manual to see where it is.

I saw somewhere on the web (maybe Chris Kotting's site) a procedure for 
changing 1500 bearings with the engine in the car, so I figure I can use this 
method and not have to completely remove the crankshaft. 


Chris King   - cbking@alum.rpi.edu

---------- Original Message ----------------------------------
From PilotRob at webtv.net (Robert E. Shlafer)
Date:  Sat, 29 Jun 2002 00:39:51 -0400 (EDT)

>Can you change the rear main bearing
>without removing the engine back plate?
>Cap'n. Bob
>    '60 :{)  

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/spridgets

<Prev in Thread] Current Thread [Next in Thread>