[Top] [All Lists]

Re: Attaching 1500 engine to stand

To: cbking@alum.rpi.edu, spridgets@autox.team.net
Subject: Re: Attaching 1500 engine to stand
Date: Sun, 30 Jun 2002 11:02:50 EDT
In a message dated 6/28/02 5:52:26 PM Eastern Daylight Time, 
cbking@alum.rpi.edu writes:

> The engine bolts are 5/16, and the holes in the stand arms are much larger - 
> will this present a problem?

It shouldn't.  I haven't put my 1500 blocks on engine stands, but I have my 
1275.  I think if you use washers under the bolt heads and draw them up tight 
you should have no problems.  I don't remember how much larger the holes are 
than the bolts.  My 1275 has been on the stand for a few years now.  

--David C.

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/spridgets

<Prev in Thread] Current Thread [Next in Thread>