spridgets
[Top] [All Lists]

Re: Heater control valve fitting

To: <spridgets@autox.team.net>
Subject: Re: Heater control valve fitting
Date: Wed, 11 Sep 2002 09:09:19 -0700
References: <20020911163658.37667.qmail@web12105.mail.yahoo.com>
Bill,

Some day when its nice and warm on a long or uphill drive, lift back the
carpet and put your hand on the tranny tunnel.  Now you know where most of
the under-bonnet heat on a Spridget escapes.  If you fill in the space with
insulation you'll soon be able to bake pizza in your engine compartment.

If you live in a really cold environment, disregard the above observation
and good luck.

Regards,
Glen Byrns
'59 bugeye
'59 Morris Traveller (Winifred)

> I also am considering filling the space between the
> wall in the engine compartment(around the bell
> housing) and the similar wall in the cabin with foam
> insulation to cut down on heat and noise.
>
> bill b.

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/spridgets


<Prev in Thread] Current Thread [Next in Thread>