Bill,
Clean them with a little sandpaper and a light coat of Kopr-Shield from
Eastwood. (www.eastwoodcompany.com) It is made from copper and comes in paste
form with a brush built into the cap. It will prevent further corrosion and it
actually helps conductivity also. Can also be used as an antisieze on manifold
bolts, etc.
Mike MacLean-60 Sprite
Bill Gilroy wrote:
> Twice last summer I was also rear ended at night. So in an effort to
> be more visible to other drivers I purchased some of the halogen tail
> and turn signal bulbs from the the Little British Car Company.
> If it prevents me from being rear ended it will be money well spent.
> If not, clean me up with a spoon :-)
>
> My question is this, what is the best way to clean the bullet
> connectors at these light. I figure steel wool or emery cloth for the
> bullet side, and maybe steel wool on a small screwdriver for the
> female side. Anybody have a better way?
>
> Second, what about coating the connection with something to prevent
> corrosion. What is best, nothing, white lithium grease, dielectric
> grease, or something else?
>
>
>
> --
> Later,
> Bill mailto:w.gilroy@verizon.net
>
> "The liver is evil, it must be punished"
> 77 Midget
> 02 Irish Terrier
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|