Is my basic subtraction wrong?? Did I get the decimal point in the wrong
Bob, you are right,
0.5630 - 0.5625 = 0.0005
0.5635 - 0.5615 = 0.0020
Sorry, something must have been distracting me!
----- Original Message -----
From "Bob Walker" <spriteracer98 at yahoo.com>
To: "Guy Weller" <Guy.Weller@kencomp.net>
Sent: Monday, February 02, 2004 7:59 PM
Subject: Re: Rocker arm clearance and Superbowl
> I come up with .0005 to .002 which is a whole lot tighter
> than you have shown. A .020 clearence can be obtained by
> flame cutting!
> --- Guy Weller <Guy.Weller@kencomp.net> wrote:
> > How can I get to my age and not know what a "snoob" is/
> > Can I use my imagination? Is that allowed?
> > Hehehehe!
> > oh, sorry, must get so easily distracted....book gives
> > rocker bushes 0.5630
> > to 0.5635 inches internal dia. and the shaft as 0.5615 to
> > 0.5625 so looks
> > like 0.005 to 0.020 range for clearance
> > Now, what was I thinking of?!!
> > Guy
> > ----- Original Message -----
> > From: "Ron Soave" <firstname.lastname@example.org>
> > To: <email@example.com>
> > Sent: Monday, February 02, 2004 4:42 PM
> > Subject: Rocker arm clearance and Superbowl
> > > Got a new rocker shaft and am going to ream bushings
> > > in rockers to fit. Is there a specified clearance?
> > >
> > > Also:
> > > 1) How many saw Janet Jackson's snoob exposed during
> > > the halftime show?
> > >
> > > 2) How many didn't notice because you were already
> > > picturing her nekkid?
> > >
> > > =====
> > > Ron Soave