Spridgeteers,
Im trying to find some bolts with the proper thread. I want to put my A
series
engine on a conventional engine stand and need 4 bolts about 4 inches long
that will fit the thread where the tranny bell housing bolts up. The ones
that
came out look like BSF or something. Anyone know what size and thread
these are and where I can get some 4" versions of them??
On a side note, once I got the flywheel off, I found some funny looking
brazing on the engine back plate. I'm going to get a picture or two of it
and post it to see if anyone can tell me what it might be and why it might
have been done....
Cheers!!
Jim - disassembled Midget in Dodge City
--
1964 R60/2
1968 MG Midget
1976 R90/6
1990 K100LT
**Don't underestimate the power of stupid people in large groups.**
|