spridgets
[Top] [All Lists]

Re: [Spridgets] Slave Cylinder

To: nases@verizon.net
Subject: Re: [Spridgets] Slave Cylinder
From: rrengineer@dslextreme.com
Date: Thu, 4 Oct 2007 11:11:33 -0700 (PDT)
Not too worried about going numb.  Just wanted to know how much trouble to
get the upper bolt out.
Mike MacLean
60 Sprite
56 BN2


Phil Nase
> Hi Mike,
> I did it on my Bugeye but you're right it's real close so you can't get
> much
> of a turn on the wrench.  When your hands go numb from holding them over
> your head, take a break;)
>
>
> Phil Nase
> Quakertown, PA
> http://home.comcast.net/~philnasecpa
>
>
> Anybody had to replace the slave cylinder on Paul's 5 speed conversion
> with
> the engine and trans in the car?  I have a leak in this area of my Bugeye
> of
> fresh brake fluid.  It may or may not be the slave cylinder.
> Might just be the line going in or the bleed extension I installed to aid
> bleeding.  If it is the slave cylinder it looks like the upper 9/16ths
> bolt
> holding the slave is very close to the frame rail.  Anyone done this?
> Mike MacLean
> 60 Sprite
> 56 BN2
_______________________________________________

Edit your replies

http://www.team.net/archive

http://autox.team.net/mailman/listinfo/spridgets

<Prev in Thread] Current Thread [Next in Thread>