spridgets
[Top] [All Lists]

Re: [Spridgets] strange problem expert needed

To: "Jerry Goodman"
Subject: Re: [Spridgets] strange problem expert needed
From: Bob Spruck <mgmaven@bellsouth.net>
Date: Thu, 18 Oct 2007 20:51:13 -0400
While vintage racing at Daytona a few years ago, a buddy broke an axle. It
was bent and shattered at the splined end in the diff. Couldn't get it out
from the flanged end. We pulled the other axle and inserted a long 1" dia
piece of pipe that was in contact with the opposite (broken) spline and
pounded like hell while turning the broken axle. It eventually pushed the
broken axle out. 





At 03:01 PM 10/18/2007 -0500, Jerry Goodman wrote:
>I have a broken halfshaft on the bugeye.  The problem is I cannot pull it
>out....It comes out about 3/8 inch and binds up.  I have tryed prying
>it..hammering it ...took out other halfshaft...slid right out.  Unbolted
>differential...but cannot remove because halfshaft stilll engaged.  If I turn
>halfshaft differential turns ....but in some positions it does not spin diffy
>so I feel certain it is a half shaft problem.  Open to any ideas
>Thank you in advance
>Jerry
>_______________________________________________
>mgmaven@bellsouth.net
>
>Edit your replies
>
>http://www.team.net/archive
>
>http://autox.team.net/mailman/listinfo/spridgets
>
>
>-- 
>No virus found in this incoming message.
>Version: 7.5.488 / Virus Database: 269.15.0/1077 - Release Date: 10/18/2007 
>9:54 AM

Bob Spruck
MGMaven
Sharpsburg, GA
67 Midget Vintage Racer
72 Midget Street and Show
6 parts/project cars
_______________________________________________

Edit your replies

http://www.team.net/archive

http://autox.team.net/mailman/listinfo/spridgets

<Prev in Thread] Current Thread [Next in Thread>