Can you do that if you don't have a welded diff? I may be confusing
it with a Ford diff but don't most diffs have a spider gear shaft in
the middle?
On 10/18/07, Bob Spruck <mgmaven@bellsouth.net> wrote:
> While vintage racing at Daytona a few years ago, a buddy broke an axle. It
> was bent and shattered at the splined end in the diff. Couldn't get it out
> from the flanged end. We pulled the other axle and inserted a long 1" dia
> piece of pipe that was in contact with the opposite (broken) spline and
> pounded like hell while turning the broken axle. It eventually pushed the
> broken axle out.
_______________________________________________
Edit your replies
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|