spridgets
[Top] [All Lists]

Re: [Spridgets] carb throttle shaft

To: "vern@srvinet.com" <vern@srvinet.com>
Subject: Re: [Spridgets] carb throttle shaft
From: David Woerpel <dwoerpel@wi.net>
Date: Fri, 30 Nov 2007 10:55:43 -0600
vern@srvinet.com wrote:
> In cleaning up my carburetors I see that the rear has
> a little slop in the throttle shaft.  The suppliers show
> oversize shafts.  Can anyone tell me what size hole
> the bigger shaft takes and is it safe to use a twist drill
> or should I look for a reamer.  Probably need a set anyway, but
> need all my available cash for parts,  Priorities, priorities.
> Vern
>
>   
Vern,  I send my Bugeye stuff to:
Jim Taylor
1222 Harned Dr.
Bartlesville OK 74006
ph: 918.333.3444

It's been 4 years but I sent my carb bodies and Jim rebushed (for the 
reason Peter gave) them, and installed the hardware new stock size 
shafts for $50.  Until the process of rebushing, one went to oversize 
shafts and then threw the carb away when they new shafts wore. 

Because folks told me I couldn't do it, I toyed with the idea of 
rebushing my H1 and H4 carbs, for fun, until I realized the problem of 
shaping the bush to match the curve of the side of the intake throat or 
getting a reamer that would give me a flat cut and not bore all the way 
through.  I was too cheap to buy the proper reamer(s).  I like Jim a lot 
and have never had any problems and he's fun to talk to.

Joe Curto Inc.
22-09 126th St.
College Point NY 11356
ph: 718.762.7878

Call Joe and hang on to your hat.  If he's got the time he's got a ton 
of knowledge and you can learn a lot.  I really must stop out there 
sometime.  He does an excellent job as well.

Dave
59 :{)
59 MGA 1500
05 MCS
Burlington WI
_______________________________________________

Edit your replies

http://www.team.net/archive

http://autox.team.net/mailman/listinfo/spridgets

<Prev in Thread] Current Thread [Next in Thread>