spridgets
[Top] [All Lists]

[Spridgets] Trooper Starter Question

Subject: [Spridgets] Trooper Starter Question
From: corvallis at peoplepc.com (corvallis at peoplepc.com)
Date: Tue, 11 Jan 2011 09:27:33 -0800
References: <AANLkTikXT3qmyxK4dX+fGYzBWhzzOGTCjCh5MAHCZz6E@mail.gmail.com>
Haven't others mentioned having to dent the footwell in a bit?  ...bill in
corvallis
--------------------------------------------------------------
-----Original Message-----
From: spridgets-bounces at autox.team.net
[mailto:spridgets-bounces at autox.team.net] On Behalf Of Kirk Hargreaves
Sent: Tuesday, January 11, 2011 8:09 AM
To: spridgets at autox.team.net
Subject: [Spridgets] Trooper Starter Question

I bought the correct Trooper starter to replace my Nippon Condenso that went
out after about 6 years of use.

The new starter turns on and works fine, but of course I only tested it
while in the car knowing that the gear was not close enough to the flywheel
gear to start the car.

For some reason I am not able to get the starter to drop down into place as
it is hanging up on something that I cannot yet see.   I am trying to not
pull my distributor.

I plan to take paper or card stock to slip in behind it today to hopefully
get an idea as to why it will not rotate down into place (the top bolt is in
place as I am trying to get the bottom bolt to line up).  Also, the bolt
distances are fine . . I just cannot get it to swing down far enough to line
up with the bottom bolt, thus allowing the gears to engage when I turn it
on.

Anyone have this same experience?

Kirk

59 1275
_______________________________________________

<Prev in Thread] Current Thread [Next in Thread>