spridgets
[Top] [All Lists]

[Spridgets] Oil Leaking From Front of 948 Engine

Subject: [Spridgets] Oil Leaking From Front of 948 Engine
From: cathe125 at suddenlink.net (cathey speichinger)
Date: Thu, 21 Apr 2011 20:32:40 -0500
References: <39136.11101.qm@web125703.mail.ne1.yahoo.com>
Get rid of the timing cover that requires the felt seal and install one that
takes the rubber seal.  BTDT ..  Don't know the crank nut torque but it can
be done without raising the motor.  Only wanted to do it once so I swapped
out timing covers.

Leo

-----Original Message-----
From: spridgets-bounces at autox.team.net
[mailto:spridgets-bounces at autox.team.net] On Behalf Of Doug Altman
Sent: Thursday, April 21, 2011 7:54 PM
To: spridgets at autox.team.net
Subject: [Spridgets] Oil Leaking From Front of 948 Engine

I've had an oil leak on the front of my 948 for a couple years now and it is
getting worse.  Going to the 50th so I guess I better fix it.  I don't think
it 
is the pan or the timing cover gaskets.  I think it is that cheesy felt
seal in 
the timing cover for the crank.  I have the felt seal to replace it. 
The 
service manual says I can remove the radiator and do the job without
having to 
raise the engine.  My question is, what is the torque for the crank
pulley 
bolt?  Also, if anyone has any helpful hints, I am open to them. 
Doug    
....o~'o 
Suggested annual donation  $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/spridgets/cathe125 at suddenlink.net

<Prev in Thread] Current Thread [Next in Thread>