I think I'll have to remove it. I can't break the bleeder loose. I was
wondering if I could jack up the engine or some such to get that one bolt
out. Sounds like I'll use Dave's suggestion.
-----Original Message-----
From: Peter Caldwell [mailto:peter@nosimport.com]
Sent: Monday, May 02, 2011 10:34 AM
To: Heard Saxon; spridgets@autox.team.net
Subject: Re: [Spridgets] clutch slave cylinder
If you want to rebuild it.... don't remove it.
If you want to replace it, morph really small fingers, and develop
lots of patience; unless the SPO shortened the upper bolt by 3/8 of
an inch. You can see the bolt at issue through the RH side footwell
plug..... but you can't turn it from there.
Also, a hint, fill the master to very full, and put a plastic bag
over the cap hole, and install the cap, that way little fluid escapes
saving you weeks of fluid-letting.
Peter C
===
At 08:45 AM 5/2/2011, Heard Saxon wrote:
>What do I have to do to remove the clutch slave from my stock '60 Bugeye?
>
>Thanks,
>Heard
_______________________________________________
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|