spridgets
[Top] [All Lists]

Re: [Spridgets] Triangular inner fender support

To: grunthaner@gmail.com, haynes386@netzero.net
Subject: Re: [Spridgets] Triangular inner fender support
From: WeslakeMonza1330@aol.com
Date: Fri, 6 May 2011 13:02:18 -0400 (EDT)
Some people fit a blanking panel but from memory this restricts engine bay  
cooling.  I guess if it really bothered you it would be possible to fit  
mesh.
 
Weslake-Monza 1330
 
In a message dated 06/05/2011 00:25:22 GMT Daylight Time,  
grunthaner@gmail.com writes:

Interesting idea I would like to know too.
Lin

On Thu,  May 5, 2011 at 2:10 PM, Mark Haynes <haynes386@netzero.net>  wrote:

> I'm not sure if I'm the only one that drives their Spridget  on dirt or 
not,
> but I have an ongoing problem with collecting (OK, a  problem with NOT
> collecting rocks) of rocks and debris between the two  frame braces just
> behind
> and inboard of the front wheels. Has  anyone thought of blocking off the
> outer
> of these two other  than me?
> does anyone think that there would be airflow (cooling)  problems created 
by
> doing this? I've been toying with the idea of  fabricating some removable
> composite panels to block the  rocks.
> I know that when I disassembled the MKII, I had to use a  screwdriver to 
get
> all of the sand out of one side, and I am  constantly (when I can drive 
it)
> vacuuming rocks out of the MKI at  this spot.
_______________________________________________

Donate: http://www.team.net/donate.html
Suggested annual donation  $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

<Prev in Thread] Current Thread [Next in Thread>