Re: bitchin small Ford starter/internal slave cylinder

[Tom Hall <modtiger@engravers.com>]

At 10:57 AM 8/6/98 +0100, you wrote:
>Gary
>I'm going to bet you the answer you get is the unit is an hydraulic throw-out
>bearing made by _ MACCLEOD!

Yes, this is the right one.


>They are known to seep fluid inside the bell housing.  

The way you prevent this is to remove the McL O-Ringed fittings on the
bearing housing and replace them with standard 90 degree fittings.  A lot
more work to install the assembly, but I have 0 leaks in three years of
operation.

Tom