Grind them out...
I have the same setup with no problem. You can run two gaskets glued together
but I did not want to take that route.
Doug
BlueGolfer@aol.com wrote:
> Darn, I just had aluminum roller rockers installed on my motor. I now find
> that they are taller than the stock rockers and interfere with the baffles
> inside the cast aluminum Sunbeam Tiger Powered by Ford valve covers. Has
> anyone else run into this problem and what did you do?
>
> I'm concerned that removing the baffles will spray oil out the holes in the
> valve covers. Perhaps there is a spacer one can buy to raise the valve cover?
>
> Rob Kempinski
> Baffled in Florida
|