tigers
[Top] [All Lists]

Re: Run On /Stalling Solved (Apparently)

To: Steve Sage <ssage@socal.rr.com>
Subject: Re: Run On /Stalling Solved (Apparently)
From: Larry Paulick <larry.p@erols.com>
Date: Sun, 27 Oct 2002 16:05:21 -0400
Steve, and All.  I have know of people who put graphite into the 
ignition switch, just like the locks on the door.

It's OK for the locks, but graphite is a electrical conduit, and excess 
will provide a source of contact between internal connections such as a 
ignition switch, if it get to these contacts.

Use a vacuum gauge to adjust the idle circuit on your carb.  This does 
it the right way, instead of guessing, and the gauge is cheap.

Steve Sage wrote:

>I think I've solved both my run on and stalling problems. Of course I 
>can't guarantee it won't happen again.
>
>As to the run-on after shutting the motor off, I just slightly leaned 
>out the Holley carb idle screws (I ended up just screwing them in no 
>more than 1/2 turn each from where they were, without effecting the 
>RPMs). No more "chugging" after the key is off. The carb must have been 
>dumping just a bit too much fuel down there at idle so it puddled after 
>the key was turned off, and was re-ignited by engine heat.
>
>The only obvious thing I could find to cause it to stall from idle 
>intermittently was the main (brown) power wire going the the back of the 
>ignition switch was not on there very tight. It must have just jiggled 
>occassionally enough to stop voltage from going to the ignition. I 
>crimped the wire on tightly and the car did no more stalling yesterday 
>or so far today. In hindsight, when I had the ignition switch out a few 
>weeks ago, I think I thought that the main wire was a bit loose but then 
>forgot to do anything about it. I still went ahead and ordered a new 
>ignition switch from SS since the other potential cause is that I think 
>the contacts inside might be sticking or wearing out. It's very stiff to 
>turn the key, and maybe that had some effect on the car stalling too.
>
>Thanks for the help from the list.
>
>Steve Sage
>
>  
>



#################################################################
#################################################################
#################################################################
#####
#####
#####
#################################################################
#################################################################
#################################################################

<Prev in Thread] Current Thread [Next in Thread>