Theo,You can accomplish the same thing if you spin a spacer to go in the
center of water pump & fits the shaft.That way you can use either standard
or Tiger only water pump.Sure helps if your away from home.Joe S.
----- Original Message -----
From: "Theo Smit" <theo.smit@dynastream.com>
To: "TM" <strombecker@shaw.ca>; "Tiger Email List" <tigers@autox.team.net>
Sent: Thursday, July 31, 2003 6:53 PM
Subject: RE: Waterpump hub
> As far as I know, the original Tiger waterpump hub was a standard
> waterpump hub, flipped back to front. My Tiger came with a conventional
> water pump (flat-front hub). When I fixed the front-to-back spacing
> problems caused by the PO having the generator mounted on a Falcon
> bracket, I went to the autowreckers and grabbed a bunch of different
> water pump pulleys to find the one that had (1) the largest diameter
> that would fit and (b) the right backspacing. I found three or four
> different pulleys that each had the same diameter, but the offsets were
> all about 1/8" different, and one of them lined up perfectly with the
> crank pulley. Then I built an alternator bracket to match. The end
> result is that I can use a standard water pump pulley, and install a fan
> without having to machine a 1" center hole in either one.
>
> Theo
>
>
> -----Original Message-----
> From: owner-tigers@autox.team.net [mailto:owner-tigers@autox.team.net]On
> Behalf Of TM
> Sent: July 31, 2003 4:10 PM
> To: Tiger Email List
> Subject: Waterpump hub
>
>
> I am looking for the hub on the tiger water pump. The one with the one
> inch center, if anyone has one to sell please contact me.
>
> Thanks Terry
> B9471362
> strombecker@shaw.ca
|