If they don't fit then there's not much you can do without modifying one
or both hard-to-replace pieces. What about using the Tri-Y castings that
occasionally show up on eBay (and are probably also for sale at a
reasonable price from others)?
Theo
-----Original Message-----
From: tigers-bounces+theo.smit=dynastream.com@autox.team.net
[mailto:tigers-bounces+theo.smit=dynastream.com@autox.team.net] On
Behalf Of Rense, Mark (GE Indust, ConsInd)
Sent: May 27, 2008 9:22 AM
To: Tigers@autox.team.net
Subject: [Tigers] Another Exhausting Tiger Question
I have a pair of 289 Hi-Po cast exhaust headers in my possession, they
offer higher flow than the original cast headers, potentially without
the issues of using tubular headers. Has anyone adapted these to Tiger
use? What is you experience?
The car I am considering for this modification uses Edelbrock Performer
RPM aluminum heads.
I will go on record again as not being a fan of tube headers on street
cars, so no need for suggestions in that regard.
Thanks,
Bugz
B382000991
B382001465
You are subscribed as theo.smit@dynastream.com
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
|