That is a nice unit but it does not fit on my car with headers.
---- Steve Laifman <slaifman@socal.rr.com> wrote:
> Ron and Eric,
>
> I found a great alternative that is actually built by Ford MotorSport.
> It was published on the TigersUnited.com site:
>
>
>http://www.tigersunited.com/resources/Dealer_Accessories/mp-FilterAdapter2.asp
>
> as co-edit by yours truly, Jim Boynton, and Mark L. (CoolVT)
>
> The Ford MotorSport Filter is a very good one. I would, as the article
> states,
>
> This Ford MotorSport aluminum SVO right angle filter adapter,
> M-6880-A50, is shown with the FRAM PH3600 in place. The Fram is smaller
> in diameter than the FL1A, which does fit as well. The design is
> different than the truck model, and has a large sealing surface on the
> mounting nut, which is not removed for filter changing. I bought it at a
> local Parts store for $50. Well, make that $100, as the first one
> bounced out of the trunk and I had to get another.
>
> While this may be difficult to obtain now, it is worth it. Notice that
> the edge car motor mount (on the left side of the car), was slightly
> rounded to prevent contact.
>
> There is a Ford Truck mount, which may be available, but isn't as nice.
>
> Steve
>
>
><http://www.tigersunited.com/resources/Dealer_Accessories/mp-FilterAdapter3.asp,,p.p1%20%7Bmargin:%200.0px%200.0px%200.0px%200.0px;%20font:%2012.0px%20Helvetica%7D,,Steve%20Laifman>
>
>
>
> Steve Laifman
>
><http://www.tigersunited.com/resources/Dealer_Accessories/mp-FilterAdapter3.asp,,p.p1%20%7Bmargin:%200.0px%200.0px%200.0px%200.0px;%20font:%2012.0px%20Helvetica%7D,,Steve%20Laifman>
>
> Editor
>
> http://TigersUnited.com
_______________________________________________
Tigers@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|