tigers
[Top] [All Lists]

Re: [Tigers] Oil consumption

To: JCMC2006@suddenlink.net, Theo.Smit@dynastream.com
Subject: Re: [Tigers] Oil consumption
From: CoolVT@aol.com
Date: Wed, 7 Sep 2011 17:19:14 -0400 (EDT)
Thanks, now it all makes sense.
 
 
In a message dated 9/7/2011 5:11:39 P.M. Eastern Daylight Time,  
JCMC2006@suddenlink.net writes:

Air is  drawn in from the aircleaner through the small hose (now clean air) 
into  the oil filler cap into the engine and ends up going out the PVC 
valve  
along with any blow by, then into the engine to be burned.

Jerry  Christopherson
9473187

-----Original Message----- 
From:  CoolVT@aol.com
Sent: Wednesday, September 07, 2011 3:54 PM
To:  Theo.Smit@dynastream.com
Cc: tigers@autox.team.net
Subject: Re: [Tigers]  Oil consumption

Theo,
If oil is drawn into the oil filler side then  why in  the original set up 
do
es the hose run from the filler cap to  the air  cleaner?


In a message dated 9/7/2011 4:50:48 P.M.  Eastern Daylight Time,
Theo.Smit@dynastream.com writes:


I   have the same setup, Mark. On the oil filler side, air is drawn into  
the
valve  cover, so there should be little if any misting on that  side unless
you have a  lot of blowby due to worn valve guides and  seals.
It  may be that some rockers are more prone to spray the oil  that gets
pumped  through the pushrodsb& with the stock Ford  rockers I had a problem
until
I put  the baffles back  in.
Theo



From: CoolVT@aol.com   [mailto:CoolVT@aol.com]
Sent: September 7, 2011 1:54  PM
To: Smit,  Theo; allanballard@att.net
Cc:  tigers@autox.team.net
Subject: Re:  [Tigers] Oil  consumption






The  oil is  getting drawn into the intake through the PCV system and  it's
getting  burned as part of the intake mixture. The only times when  you  
might
notice this is if you're idling and the wind is from behind   you. On an F4B
intake, you'd notice that the #4 plug is more prone to   fouling because the
PCV
is plumbed into that intake   runner.

Theo

On  the subject of baffles and PVC's.  I  have my PVC connected, but on the
oil filler cap I am using just a screened  cap.  I haven't noticed any
misting because of this being an open  system, but maybe over time it will 
show
up.



My   questions is:  is it possible to be getting an exhaust smell because  
of
one side being open?

Oh,  and no oil consumption with the  baffles  removed.

Mark







____________________________________
This  e-mail and any attachments may contain  confidential material for  the
sole use of the intended recipient. If you are  not the intended  recipient,
please be aware that any disclosure, copying,  distribution  or use of this
e-mail or any attachment is prohibited. If you  have  received this e-mail 
in
error, please contact the sender and delete  all  copies.

Thank you for your   cooperation.
_______________________________________________

tigers@autox.team.net

Donate:  http://www.team.net/donate.html
Archive:  http://www.team.net/archive
Forums:  http://www.team.net/forums
Unsubscribe:  
http://autox.team.net/mailman/options/tigers/jcmc2006@suddenlink.net
_______________________________________________

tigers@autox.team.net

Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums


<Prev in Thread] Current Thread [Next in Thread>