tigers
[Top] [All Lists]

Re: [Tigers] Carb install - at least it's not leaking

To: tigers@autox.team.net s=q20121106; t=1371477093; bh=T+PiTYXDpeXRIpzSFehm8bg+7dqujDzexed5tfQy+dc=; h=Received:Received:Date:From:To:Message-ID:Subject:MIME-Version: Content-Type; b=JaRJKtcOqoBfl6EtYY69/X4V9ayP9pL/PSvWWEdaMmQI+Mnt8hXuInBT4NC10WYvY /bTb0gI2OxRNGsuu9qjqat8FyYUHkWHFgvaRxfoRE89Nt4UQwJQt60+Awhi767FmX0 RnNhQ9pPNC9JRhUsQsFMVRRjq5Iau3eV5CYhufq9Lsd6kvXhrP1ZYFwWmZXzyPdoHD 3FiwsXl+Nl53cc8QuwE0Sd7r3Uzq/ED53GRru8lPLA7H8Jk/XZ142QbJCd9852IxHb msAxkrjLY4o+J9TqD+oMadTH8+iQtNQDH4v2Q7tlMt/RviDxatJOA8qSloYmL7knt2 FyyyebevtJViQ==
Subject: Re: [Tigers] Carb install - at least it's not leaking
From: Gary Winblad <garywinblad@comcast.net>
Date: Mon, 17 Jun 2013 13:51:33 +0000 (UTC)
Delivered-to: mharc@autox.team.net
Delivered-to: tigers@autox.team.net
Jay,
The choke is only used when the motor is cold.  Once the motor is warm, the
choke
plate SHOULD be open all the way.  In California, you don't even need the
choke,
I haven't had my choke plates closed in 40 years!
To find your problem, I would set it fully open.  I would guess that a small
bit of that
old gasket has plugged a passage somewhere (air or fuel passage).
Look to see that the secondary throttle plates are closed, then just work on
the front
section, that is where the problem is.
Gary

    ----- Original Message -----  From: Ron Fraser <rfraser@bluefrog.com>  To:
'Jay Laifman' <jay.laifman@gmail.com>  Cc: tigers@autox.team.net  Sent: Sun,
16 Jun 2013 19:43:05 -0000 (UTC)  Subject: Re: [Tigers] Carb install - at
least it's not leaking    Jay      The black cover is the automatic choke with
a heat pipe - the  covered tube.    You should be able to feel some spring
tension by pushing on the choke  plate.    It is possible the choke and the
bi-metal spring inside that cover are not  engage properly.    There should
also be a mark on the choke cover that usually lines up with  one of the
casting marks.    Loosen the 3 screws on the choke cover to see and feel if
the choke plate  will move with the cover as it turns.    Secondary throttle
plate should be closed, primary throttle plate should be  very near closed -
this is the idle set    Ron    -----Original Message-----  From: Jay Laifman
[mailto:jay.laifman@gmail.com]  Sent: Sunday, June 16, 2013 3:20 PM  To:
rfraser@bluefrog.com  Cc: michael@michaelshortt.com; tigers@autox.team.net
Subject: Re: [Tigers] Carb install - at least it's not leaking      Here is a
picture of the way it looks right now.  Shouldn't that throat  plate be in the
closed position?  Or is it supposed to be open?  I wonder if  I have the choke
attached incorrectly and it is keeping it open.    Jay
_______________________________________________    tigers@autox.team.net
http://autox.team.net/mailman/options/tigers/garywinblad@comcast.net
_______________________________________________

tigers@autox.team.net

Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/tigers/mharc@autox.team.net


<Prev in Thread] Current Thread [Next in Thread>