Listers,
I'm still fighting the issue I'd raised earlier: none of the vendors
sell new fuel filler necks (the rubber "tube" that connects the filler
cap to the tank) for the GT6 Mk III.
The original is roughly a 1 3/4" Inner Diameter tube about 7 inches long
with about a 30 degree bend in the middle.
I've had several people offer to check parts yards, for which I am truly
grateful. However, any parts yard filler neck is likely to be close to
25 years old!!
Does anyone have a source other than the ones I've tried (SICP, VB, TRF,
Rimmer, Racers Wholesale)? Or does someone have an alternate (Ford
"fill in the model" filler neck can be cut down, etc?)?
Or alternatively, if I can find an alternate solution to the factory
part, what interest would there be from fellow listers? If I can
convince a racing supplier that there is enough demand to justify
stocking or fabricating the part... it'd be a big help.
TIA
Jim
gambony@hotmail.com
______________________________________________________
Get Your Private, Free Email at http://www.hotmail.com
|