There is an old TSB from Triumph that talks about using a hot water
bottle to roll across the creases.
Joe Burlein
72 TR-6
Melbourne, FL
On Sat, 20 Mar 1999 18:19:44 -0500 George Richardson
<gprtech@frontiernet.net> writes:
>
>You don't have to wait for the crease to come out. When you are
>putting the
>cover on the dash, you need to pull it tight- VERY tight. If you don't
>stretch
>it when installing it, you'll have severe problems with creasing when
>you wrap
>it around edges.
>
>When you go to do it, lay it out in the on a bright day, just like you
>would
>with the tonneu or top.
>
>Mark Gendron wrote:
>
>> My vinyl dashboard cover (TR2) arrived from TRF. However, it was
>folded
>> several times for packaging. I have laid it flat for several days
>but the
>> creases won't flatten. What is the proper method for removing
>creases from
>> vinyl?
>>
>> Thanks
>> -mg
>> 1954 TR2 TS2571L
>
>
|