triumphs
[Top] [All Lists]

Re: repo ball joints and tie rd ends tr3

To: richard white <rhamm@peachnet.campuscwix.net>
Subject: Re: repo ball joints and tie rd ends tr3
From: Robert Dowdy <ABCDOWDY-METU@worldnet.att.net>
Date: Fri, 15 Oct 1999 07:53:36 -0700
Cc: triumphs@autox.team.net
References: <000e01bf168b$fe5df960$c30a0ea8@oemcomputer>


My problem was with the grease seals and when I contacted TRF I was swnr
replacement seals and was told that sometimes they receive bad batches of
improperly manufactured seals. all the seals were replaced 6 months ago and so
far no problem with replacements.

richard white wrote:

> Several years ago I purchased new suspension parts for the front end of my
> project.  About a year ago I put everything back on the bare frame.  This
> past week I put the engine and trans on the frame, and I noticed that all of
> the boots on the tie rod ends and ball joints were split and disintegrating.
> Has anyone else had this problem?
> Is there a source of good replacement boots?
> Should I be worried about the quality of the ends and joints themselves?
> TIA
> Richard White
> Tr3a






<Prev in Thread] Current Thread [Next in Thread>