Mike,
I always put a dab of axle grease on the threads before i put them in.
This is very important with aluminum heads on my T140V. Never had a plug
seize up.
Bob Labuz
1958 TR3A
1974 T140V
Mike Barron wrote:
> Tried to remove and replace the plugs on the "weenie" a few weeks ago
> (TR3) and got two out, and gave up on the other two, and tightened
> them back up. COULD NOT get them out. Going to try using WD40 to
> lubricate the threads by loosening, spraying, tightening and
> loosening, and repeating the process until plugs come out. Question:
> How do I prevent this in the future? (Providing I am successful in
> getting them out this time)
|