Hay Listers,
I got a crude measurement on my end float. It was about 1/32 of an inch.
Don't think my thrust washers are in the oil pan but they do need attention.
Are any sources for thrust washers better then any other? I looked at a web
site article who's author makes thrust washers out of bronze material. Any
advantage?
Lastly is there anything I should look out for while doing the work? Any
help appreciated.
Bob Rochlin
72' TR 6
///
/// triumphs@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe triumphs
///
///
|