Do the TR7 plug wires share the same end details (size and form of the
fittings at the distributor cap) as the TR250/TR6/GT6? Someone
mentioned the closeout of TR7 plug wires at Crane Cams and I was
thinking this might be an inexpensive way to build up a spark plug wire
set, buying 2 sets and choosing the ones that have an agreeable length.
If not where can one get inexpensive spiral wound plug wire sets for a
TR6 engine. I just purchased a Crane PS60 coil and the instructions
mentioned that the use of resistor plug wires (what I have now) results
in a 30% decrease in current delivered to the plugs as compared to plug
wires that have less than 800 ohm per foot of length.
/// triumphs@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe triumphs
///
|