> I installed new "modern" front oil seals on my hubs but I still feel
> they are too loose after using the Haynes Manual technique of tightening
> to 10 lbs. torque and backing off 1.5-2 flats. Actually, when I only
> back off the recommended # of flats the hub feels as if it's binding a
> bit so I back off a bit more. Should I feel a bit of binding when
> adjusting as instructed?
No, there shouldn't be any binding, especially with the lip type seals. I'd
be looking real close at the back of the hub, to see what's rubbing. Might
even spray it with machinist's dye, to see where it rubs.
> How much play should there be when grabbing the
> wheel at the 12-6 o'clock position?
The factory adjustment produces a small amount of play when cold.
Randall
/// triumphs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|