Terry, I don't know if that particular plywood would be the right choice or
not, but, for what it's worth, I chose an exterior grade for the waterproof
glue and then added several coats of polyurethane after it was bent to form.
Bob
----- Original Message -----
From: "Terry Smith" <terryrs@adelphia.net>
To: <triumphs@autox.team.net>
Sent: Tuesday, July 12, 2005 8:57 AM
Subject: Seat Recovering
> Hello, everyone.
>
> I'm on vacation this week. The weather is hot outside, for New Hampshire,
so
> it seems a good time to get outside and recover my TR3A seats. I've
already
> restored the seat pans, so my first question involves the wood strips.
>
> Is floor luan plywood acceptable for these? (That's the stuff that goes
> underneath a ceramic tiling project.)
>
> I'm searching for a good web page describing the reuphostery process. An
> recommendations on that?
>
> Thank you all yet again.
>
> Terry Smith
> '59 TR3A. Body still off. Rest mostly done.
> New Hampshire.
|