On Monday 24 July 2006 06:59 pm, Tony and Jeanne wrote:
> List,
> Can anyone tell me if the stud on the oil filter that connects to the
> oil pressure gauge is drilled or something of a special stud?
> I guess I'm trying to figure out how the oil pressure gets around the
> stud to feed the banjo fitting.
> Jeez, when I took it all aprt I marked all the parts and placed them in
> zip lock baggies, so I'm pretty sure that I have the correct stud.
> I have the wahers and the cap nut, I know those are correct.
> Any help would be appreciated......I did look in the book and it just
> calls for a stud. No note of anything special.
> Tony
> 58 TR3A
> TS27093
> Wiring about 80% done, soon will be back in the body shop to hang wings,
> bonnett and boot.
>
Tony,
The oil gets to the line due to the gap provided by the lower washer. The
lower washer should have a larger inner diameter I believe. I know the 2
copper washers are different in some way.
Bob
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|