> > I am continuing to reassemble the rear axle. The
> car did not have
> > the 'straps" that stabilize the rear brake lines.
> I notice that the
> > usual sources want $2 - $3 for each. Is there
> something else I can
> > use? I was thinking about some plastic tie wraps,
> any suggestions??
> How about plastic tie wraps? Or stainless hose
> clamps? I would advise
> against safety wire.
I have used plastic tie wraps and the "Adel" clamps
(rubber lined wrap-around clamps with a hole to secure
it at handy place type of clamp) on the race cars. If
the hard line is a short run and out of the way of
things, sometimes I use nothing.
=== This list supported in part by The Vintage Triumph Register