triumphs
[Top] [All Lists]

Re: [TR] TR3 Brake help

To: "marty sukey" <trmarty@hotmail.com>, "Triumph List"
Subject: Re: [TR] TR3 Brake help
From: "Kinderlehrer" <Kinderlehrer@comcast.net>
Date: Tue, 10 Nov 2009 19:54:57 -0800
My approach when faced with this problem was to take one of the flexible 
lines, which I was replacing anyway. and cut it in half.  I then took a tire 
valve and carved away the rubber from the bottom part leaving a brass tube 
which fits nicely into the cut end of the brake hose. (I may have actually 
run it through a die to cut threads into it and then screwed itinto the 
hose, it's been awhile) A hose clamp or even twisted wire to secure the hose 
to the valve would probably help, but I don't think I needed it.  I then 
reattached the hose to the caliper and, because at the time I didn't have a 
compressor, I used a bicycle pump on the tire valve and one caliper popped 
out. I put it back in and secured it with a C clamp and pumped again until 
the other one popped.

Worked for me.

Bob

----- Original Message ----- 
From: "marty sukey" <trmarty@hotmail.com>
To: "Triumph List" <triumphs@autox.team.net>
Sent: Monday, November 09, 2009 7:42 PM
Subject: [TR] TR3 Brake help


>A friend of mine is restoring a TR3 that has set for years. He has picked
> quite an ambitious project. He brought over the front brake calipers this
> evening looking for advice. One is for sure toast. The other he cannot get 
> one
> of the pistons out of. He has had it soaking in a pan of blaster for a 
> week
> and it wont budge. Pretty much destroyed the piston trying to get it to 
> move.
> First question, on the back of the caliper there is what appears to be a 
> plug
> with a large screwdriver slot in it. It looks like if this plug was 
> removed
> the piston could be pushed out. However, he says the manual states DO NOT
> REMOVE THIS PLUG. Can this instruction be ignored? He is trying to work on
> this car a little at a time and does not have a big budget. Is there any
> possibility of converting over to a TR6 disc brake set up or something 
> else
> that is more available? I'm not familiar with the TR3's. Any advice?
>
> Thanks,
> Marty
_______________________________________________

Support Team.Net  http://www.team.net/donate.html

This list supported in part by the Vintage Triumph Register
http://www.vtr.org


Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>