[Shotimes] can u start motor in nuetral with no tranny fluid

[Ian Fisher]

I am confused; aren't you going to have to install the halfshafts at
some point anyway? Either way, you can install the upgrade without the
halfshafts on the car..

Ian


-----Original Message-----
From: shotimes-admin@autox.team.net
[mailto:shotimes-admin@autox.team.net] On Behalf Of don donelson
Sent: Thursday, November 21, 2002 10:42 AM
To: shotimes@autox.team.net
Subject: [Shotimes] can u start motor in nuetral with no tranny fluid


I just re-built a motor for a cust .... and still have a 96 brake up
grade to do ... there fore I dont want to put the half shafts in just to
start the motor and make sure all is well.

The tranny is currently "DRY" .. no fluid ..... and in nuetral .... i
know the input shaft is turning .... but no other gears . Will this
damage the input shaft ... ie the bearings at either end that support it
..... I have also thought just to get a small piece of 4 x 4 to hold the
clutch down .... which should prevent the input shaft from turning ....

Any thoughts on those in the know ?


dond
91 Super SHO II

Best part ... I did all the work & assembly  : )
Engine runs like a scalded dog ! No leaks / No errors !

-3.2 ATX block
-FPS hi-flow heads w/  over sized valves
-Stage I cams
-SHONUT adjustable timing sprockets
-Ported intake & runners
-Ported and extrude honed exhaust manifolds
-Hi-flow catless Y pipe
-Hi-flow exhaust
-BBB
-SHO SHOP T.B.
-SHONUT phenolic spacers
-Quaife
-CAI
-UDP
****
-Cowl hood
-Momo 17x8 rims
-Police grill
-Custom two tone interior
-Complete sunpro gauges
oil temp / water temp / oil pressure
****
-Tokico shocks/Eibach springs
-Polyurethane at all corners
-Solid-sub frame bushings
-Frame stiffners
-Adjustable rear control arms
-Battery located in trunk for better weight distrubution
****
-12" rotors at all four corners
-Steel braided lines _______________________________________________
Shotimes mailing list
Shotimes@autox.team.net http://www.team.net/mailman/listinfo/shotimes